Ozone Monitors - Series-100
Aeroqual’s
integrated ozone monitor, controller and switch is designed to be operated as
part of an ozone generator control circuit or alarm system.
Monitor Specifications
| Sensor type |
Gas Sensitive Semiconductor (GSS) |
| Measurement range |
|
| Low
concentration Ozone Head |
0.000 to 0.500 ppm |
| High
concentration Ozone Head |
0.00 to 5.00 ppm |
| Accuracy |
|
| Low
concentration Ozone Head |
+/- 0.010 ppm (0 to
0.100 ppm) |
|
+/- 10% (0.100 to 0.500
ppm) |
| High
concentration Ozone Head |
+/- 10% (0.20 to 5.00
ppm) |
| T90 response time
(standard) |
|
| Low
concentration Ozone Head |
100 seconds |
| High
concentration Ozone Head |
35 seconds |
| Operating temperature
range |
-5°C to 50°C |
| Relative humidity
limits |
5% and 95% |
| Removable/replaceable
sensor heads |
Yes |
Controller/Switch Specifications
• User adjustable high and low control and switching set points
• User adjustable control ‘dead band’
• External trigger signal for control and switching (user supply): 12 volts,
150 mA
• LED status indicators: High/low/within control band, fault/failure
• Power Requirements (User supplied): 12 VDC, 400 mA
• Unit Interface (power in, control signal out): RJ45 connector.
• Height (with monitor): 64 mm; Diameter of base: 130 mm
Low concentration Ozone Sensor Head
The low concentration ozone sensor head has been designed to not normally
require recalibration for the life of the sensor head.
High concentration Ozone Sensor Head
The high concentration ozone sensor head is designed to provide a rapid
T90 response. To maintain accuracy, an on-board reset routine can be implemented
periodically (in the absence of ozone). This operation is a performed on a Series-300,
or Series-500 monitor via the "Reset routine" menu option during routine
maintenance cycles. The frequency of the maintenance cycle is dependant on the
application conditions and level of accuracy required by the user.
Series-100 PDF
File
See Aeroqual's
other products
Contact
us for more information.
